Starting The Engine (Honda) - Stiga MULTICLIP 46 S Instructions For Use Manual

FILL UP THE PETROL TANK
Never remove the filler cap or fill with
petrol while the engine is running or still
warm.
Never completely fill the petrol tank. Al-
low a little room for the petrol to expand
if necessary.
Preferably use an environmentally friendly petrol,
i.e. alkylate petrol. This type of petrol has a com-
position that is less harmful to people and nature.
It has e.g. no lead additives, no oxygenators (alco-
hols and ethers), no alkenes and no benzene.
NOTE! If you change to environmental-
ly friendly petrol in an engine previously
run on ordinary lead-free petrol (95),
the petrol manufacturer's recommen-
dations must be followed carefully.
Ordinary lead-free 95 octane petrol can also be
used. You must never use 2-stroke petrol mixed
with oil. NOTE! Bear in mind that ordinary lead-
free petrol is a perishable; do not purchase more
petrol than can be used within thirty days.
STARTING THE ENGINE
(Briggs & Stratton)
1. Place the lawnmower on flat, firm ground. Do
not start in long grass.
2. Make sure the spark plug cable is connected to
the spark plug.
3. If the lawnmower is equipped with throttle con-
trol, set the throttle control N to full throttle
(fig. 8, 9).
4. When starting a cold engine: Press down the
primer fully 6 times (fig. 10, 11).
When starting a warm engine the primer does
not need to be used. If the engine stops due to a
lack of fuel, refill and press down the primer 3
times.
5. Press the Start/Stop loopG towards the handle.
NOTE! The Start/Stop loopG must be kept
pressed in to prevent the engine stopping (fig.
8, 9).
6. For ease of starting, press down the handle so
that the front wheels lift slightly from the
ground. Do not start in thick grass.
Multiclip 46 SGrasp the starter handle and start
the engine by pulling briskly on the starter cord.
ENGLISH
Multiclip 46 SE: Start the engine by turning the
ignition key clockwise. Release the key as soon
as the engine starts. Always make short at-
tempts at starting in order to prevent the battery
running down.
7. For the best mowing results, the engine should
always be driven at full throttle.
Keep hands and feet away from the ro-
tating blade. Never put your hand or
foot under the blade casing or in the
grass ejector while the engine is run-
ning.

STARTING THE ENGINE (Honda)

1. Place the lawnmower on flat, firm ground. Do
not start in long grass.
2. Make sure the spark plug cable is connected to
the spark plug.
3. Open the fuel tap (fig. 12).
4. Move the throttle control N to the choke posi-
tion . NOTE! It is not necessary to use the
choke position when the engine is warm (fig.
8).
5. Press the Start/Stop loopG towards the handle.
NOTE! The Start/Stop loopG must be kept
pressed in to prevent the engine stopping (fig.
8).
6. Grasp the starter handle and start the engine by
pulling briskly on the starter cord.
7. When the engine starts, move the throttle con-
trol backwards until max. revs are obtained.
NOTE! The engine should always be run at
maximum revs to avoid abnormal machine vi-
brations.
Keep hands and feet away from the ro-
tating blade. Never put your hand or
foot under the blade casing while the en-
gine is running.
ENGAGING/DISENGAGING THE
DRIVE
Engaging the drive is facilitated by pressing
down the handlebar so that the driving wheels
are raised slightly from the ground.
Engage the drive by pressing the clutch loop I to-
wards the handle. Disengage the drive by releasing
the clutch loop I (fig. 8, 9).
GB
7