Table of Contents
Advertisement
SSL VPN dropping connections
SSL VPN dropping connections
62
Destination
wan1
Destination address
remote VPN subnet
Action
ipsec
VPN tunnel
<vpn phase1 name>
When a FortiGate unit has multiple internet connections, the SSLVPN client can
connect to the SSLVPN web portal, but when attempting to click Connect to start
tunnel mode SSLVPN, the tunnel will start up for a few seconds, then shut down.
This issue occurs when there are multiple interfaces connected to the Internet, for
example, a dual wan configuration.
To resolve this issue, upgrade the FortiGate unit to at least 3.0 MR4 or higher.
Use following commands in CLI to resolve the issue:
config vpn ssl settings
set route-source-interface enable
end
Note: This CLI command is only available in FortiOS 3.00 MR4 and higher.
Configuring a FortiGate SSL VPN
FortiOS v3.0 MR7 SSL VPN User Guide
01-30007-0348-20080718
Advertisement
Table of Contents
