Table of Contents
Advertisement
5.1.4.4 Network Setting
In the Network Setting dialog box, click Update to accept the new settings, click Exit to exit without
saving, and click Default to revert back to original factory setting. For the network service ports that use
by NVR server, please see
If user has changed the configuration and cause remote NVR's IP address has changed, the
i
remote NVR system will disconnect the remote access connection automatically.
(1)
(2)
(1) Server Name
Assign a name for the NVR unit. Alphabet letters and numbers only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section you want to make it
accessible via internet using WebViewer, Remote Console, PDA Viewer and JavaViewer (still image). To
select all the cameras, enable the ALL check box.
(3) Network Time Synchronization
Adjust the NVR system time same as network time server. Fill in the Time Server IP address or domain
name. Select the Time Zone that NVR is located. And then, mark the Automatic Synchronize time to
set automatic synchronize time on a daily basis.
(4) Other Configuration
-
Enable White List
An access permit list for the remote accessing of NVR server. Enter the IP address and click Add.
Or, enter a range of IP address and click Add. To delete the IP from the list, select the IP and click
Delete button. To reset the input, click Clear button.
i
When user changed IP range in white list setting and it causes the IP address of PC that connected with
-
remote NVR server has been excluded in white list, the remote NVR server will disconnect the
connection automatically. Please change the IP address of PC to the IP range in white list and
re-connect with remote NVR server.
-
Without any IP address/IP range is assigned in White List table, none of IP address/IP range is allowed
to access NVR when White List function is enabled.
Appendix
A.
70
(3)
(4)
Advertisement
Table of Contents
