Charging The Battery Pack - Sony Cyber-shot DSC-TX300V Instruction Manual

Charging the battery pack

1
Connect the Multi Station (supplied) to a computer,
using the micro USB cable (supplied).
2
Set the camera on the Multi Station.
The ACCESS lamp and CHARGE lamp on the Multi Station will light up.
• With the camera screen facing upward, set the camera on the Multi
Station as illustrated.
• If the CHARGE lamp flashes continuously, make sure that there is no
dirt or other foreign matter on the Multi Station, and that no camera
other than this camera is connected to the Multi Station. After that,
disconnect the micro USB cable once and connect it again.
3
Make sure that charging has started.
The Power/Charge lamp lights orange, and charging starts.
• Turn off the camera while charging the battery.
• You can charge the battery pack even when it is partially charged.
• When the Power/Charge lamp flashes and charging is not finished,
remove and re-insert the battery pack.
GB
12
ACCESS lamp
CHARGE lamp
Power/Charge lamp
Lit: Charging
Off: Charging finished
Flashing:
Charging error
Charging paused due to overheating