Honeywell RAPID EYE MULTI-MEDIA Operator's Manual page 76

View: Operator Guide
How can Multi events be processed?
Events are set during site-by-site maintenance sessions, to either:
6.7.1 Maintenance Session
! ! ! ! 85 To start a maintenance session
A maintenance session only affects the site that is selected.
1.
2.
Wait for the "System Operational" message in the Feedback box. See figure 62 on
p. 6–13.
! ! ! ! 86 To end a maintenance session
Do any one of the following:
Using Apply and Restore
Apply/Reset button. Used after changes are made to Events and Data recording. The
Apply/Reset button remains active, when you click another tab to which no changes
have been made.
Restore button. Works like an "undo": the settings at the start of the maintenance
session are re-applied. Quitting the maintenance session ends the possibility of restoring
previous settings at that site. For example, suppose that you make changes on a tab,
click Apply, click another tab and click Apply a second time; clicking Restore brings the
6–12
sound an alarm. View operators are warned when the event occurs. Operators
can use information about it, to search for video at the time of the event. See
figure 56.
be logged. The event name and its time are logged on the remote video unit.
Logged events are not listed during an alarm session. See figure 76 on p. 10–1.
do both. An event can sound an alarm and be logged.
do nothing. This is the default setting for some events. Unless set to do
otherwise, these events are not logged, nor do they set off alarms. See table 15
on p. 6–16.
Do either one of the following:
select a site, then click
right-click a site and selecting Maintenance in the shortcut menu
If a Connections dialog appears, choose the connection recommended by your
Multi SA and click OK. The maintenance tabs are displayed.
click
click Disconnect on the Actions menu
close the Maintenance window
close View.
on the toolbar.