Shure ULX-D User Manual page 104

Overview of Dante Network Modes
The Dante network interface has two ports (Primary and Secondary) to provide flexible routing and configuration options for network signals.
Three selectable Dante network modes are available to control signal routing from the receiver ports to the Dante network.
Network Mode
Shure Control
Dante Audio and Control
SWITCHED
REDUNDANT AUDIO Dante Redundant Audio
SPLIT Dante Audio and Control
Setting the Dante Networking Mode
Select a Dante mode to configure network signal routing on the Primary and Secondary ports.
Set all receivers on the network to the same mode.
Note: Remove network connections from the receiver before changing the mode.
1. From the receiver menu:
DEVICE UTILITIES
2. Use the control wheel to select a mode (
3. Press to save.
ENTER
4. Cycle receiver power to enable the mode change.
16
Port Function and Signals
Secondary
Shure Control
Dante Audio and Control
Shure Control
Dante Audio and Control
Shure Control
> >
NETWORK CONFIGURATION
,
SWITCHED REDUNDANT AUDIO
Primary
For single network Installations of star or daisy-chained
networks.
Primary and Secondary ports are configured are 2 separate
networks. The Secondary port carries a backup copy of the
Primary digital audio signal.
Primary and Secondary ports are configured are 2 separate
networks to provide isolation between control signals and
audio signals.
CONFIGURATION
SWITCHED (default)
, )
SPLIT
Application