Table of Contents
Advertisement
Installation
Ensure that the electricity supply is turned off
GB
before installing your appliance.
IMPORTANT
DO NOT LIFT OVEN BY THE DOOR HANDLES.
This equipment is designed specifically for
domestic purposes and Hotpoint Limited cannot
accept responsibility if used for any other type of
application.
All electrical installations must be carried out by
a NICEIC registered installer.
WARNING: THIS APPLIANCE MUST BE EARTHED.
1. General
The appliance is designed for mounting at a safe
level into an open housing which must be
secured to the backing wall.
2. Oven Unit Housing Cabinets
• The oven unit housing cabinet dimensions
must comply with Fig. 4.
• An air gap of 50 mm minimum must be
provided at the rear of any top or bottom
cupboards or shelves. (See Fig. 1).
• Ventilation must be unobstructed, ie. From
adjacent cabinetry. This can be done by
either raising the base of the cabinets using
the adjusting feet (or spacers) or alternatively
by providing a slot in the cabinet plinth to the
dimensions shown overleaf.
• The air gap at the rear allows the warmed air
to pass out of the inner cabinet space, but
where it is intended to fit cupboards above
the oven unit to ceiling height it is essential
that the warmed air is exhausted through the
front of the cabinet Fig. 1.
• If an oven unit is installed adjacent to a tall
cabinet, steam escaping from the oven when
the door is opened could condense on, and
perhaps stain, the adjacent surface. To
prevent permanent staining, the adjacent
surface should be made of a material that is
heat resistant and easy to clean. Adjacent tall
cabinets should not be deeper than the oven
housing cabinet.
4
IMPORTANT
It is essential that the lower cupboard is constructed
in the manner illustrated. having side, back and roof
panels so joined as to provide no apertures which
could permit access to the oven unit when installed.
3. Final Installation
• Using a spirit level, check that the housing
cabinet is level from side to side and from
front to back in its installed position.
• Correct any unevenness by placing wooden
packing under the bottom of the cabinet.
Make sure that the cabinet rests firmly on the
cabinet floor without rocking.
• Before the oven is fitted, the cabinet must be
firmly secured to the backing wall for stability.
• The oven unit should now be lifted (by 2
adults) into the cabinet and pushed fully
home.
• Finally the oven unit must be secured to the
cabinet by means of the four pozi wash head
screws, two through each side trim.
• REMOVE ALL PACKING MATERIAL FROM
THE GRILL AND OVEN INTERIOR.
List of Loose Items
4 x Pozi Wash Head No. 6 x 15mm screws.
Fitting the guide rails
Fitting the guide rails
Fitting the guide rails
Fitting the guide rails
Fitting the guide rails
For the sake of re-fitting the guide-rails of the oven
e.g. after cleaning, begin with the lower holes on the
right side and the upper holes on the left side. Insert
the two pins "H" into the holes provided and fit the
support "A" between the two plugs "G"
G G G G G
G G G G G
A A A A A
H H H H H
Advertisement
Table of Contents
