Temporarily Raising And Lowering The Temperature; Fan Operation - Aprilaire 8570 Owner's Manual

2. Temporarily Raising and Lowering the Temperature

You can raise or lower the temperature by simply pressing the Up/Down buttons, then SAVE.
Example: The Setpoint is at 68°, you want the temperature to be 72°.
HOLD THIS
3/11/05 5:15PM HOLD TIL
TEMPERATURE
OUTDOOR HEAT MODE OUTDOOR
20° FAN AUTO UNTIL 10:00PM 20°
HEAT HEAT
68° 68°
72°
SETPOINT
HEAT 68
RESUME
INFO MENU BACK SAVE PROG. MENU
If you are in AUTO Mode, both heat and cool settings will be displayed on the hold screen.
First you can change the Heat setting, then the Cool setting. If you do not want to change one
of these settings, simply select the to go to the next setting or BACK to go to the
or
main screen.
HOLD THIS
8/27/05 5:15PM
OUTDOOR AUTO MODE TEMPERATURE
81° FAN AUTO UNTIL 10:00PM UNTIL
HEAT HEAT COOL HEAT
76°
71° 71°
76°
SETPOINT
HEAT 71
COOL 76
INFO MENU BACK
If you were running the temperature program when you made the change, the message center
displays when the thermostat will return to programmed operation. Press the RESUME PROG.
button to return to programmed operation at any time.
6
10:00PM
HEAT MODE
FAN AUTO
SETPOINT
HEAT 72
HOLD THIS
HOLD TIL 10:00PM
TEMPERATURE OUTDOOR COOLING
10:00PM 81° FAN AUTO
COOL COOL
76°
74°
SETPOINT
HEAT 71
RESUME COOL 74
SAVE PROG. MENU

3. Fan Operation

The thermostat allows you to operate the fan manually or it can change the fan setting for you automatically with
each programming event.
For manual operation, from the MAIN MENU simply select SET FAN: ON to run the fan all the time, or
SET FAN: AUTO to run the fan only during heating and cooling calls.
NOTE: When installed with an Aprilaire Model 6504 you will be given the option to CHANGE ALL THERMOSTATS.
®
If you select YES to this, the fan setting will be set to whatever you have selected for all the thermostats on the system.
9/11/05 5:15PM MAIN MENU 9/11/05
OUTDOOR OFF MODE SET MODE: OUTDOOR
OFF
45° FAN AUTO 45°
AUTO
COOL
HEAT
72° 72°
SET FAN:
AUTO
ON
ON
MORE
INFO MENU EXIT SELECT INFO MENU
For automatic operation, select PROGRAMMED FAN from the MAIN MENU, and then select ENABLE. In the Fan Status
setting screen, you set the fan to be either ON or AUTO during each of the programming events (see page 10 for
details on the programming events). Use the and
the to change to ON or AUTO. Once you are done, use the
or
PROGRAMMED FAN PROGRAMMED FAN
MAIN MENU
MORE
DISABLE
WAKE WAKE
HOLD
PROGRAM LEAVE
PROGRAMMED FAN PROGRAMMED FAN
RETURN
SETTINGS ENABLE
ENABLE
SLEEP
SET DATE AND TIME
DONE
EXIT SELECT
BACK SELECT
5:15PM
OFF MODE
FAN ON
buttons to move to the Fan Status you wish to change, and use
button to highlight DONE and then press SAVE.
PROGRAMMED FAN
FAN STATUS
FAN STATUS
AUTO AUTO
WAKE ON
AUTO
LEAVE AUTO
AUTO
RETURN ON
AUTO
SLEEP ON
DONE
DONE
CANCEL SAVE
7