Table of Contents
Advertisement
Symphony 32 PCI card – User's Guide
Installing the X-Symphony card
Your X-Symphony card should include the following:
2
1 X-Symphony circuit board
1 X-Symphony Coverplate
2 aluminium standoffs
1 plastic standoff
1 Remove the top cover of the host interface.
2 Remove the Option Card coverplate, and set aside the screws for
later use.
3 Remove the two interface circuit board screws indicated at left, and
set them aside for later use
4 Install the two aluminium standoffs in the threaded holes vacated
by the screws.
4
5 On the X-Symphony card, install the plastic standoff in the hole
adjacent to the multi-pin motherboard connector.
3
6 Insert the Port connector end of the X-Symphony card through the
host unit back panel, and carefully place the multi-pin motherboard
connector in the mating connector found on the host interface
motherboard.
7 After verifying the alignment of the multi-pin and the mating con-
nectors, firmly press down on the X-Symphony card, over the con-
nector, until the pins are completely seated in the mating connector.
8 Re-install the circuit board screws from Step 3 in the locations
indicated below.
9 Install the X-Symphony Coverplate, and secure it to the host inte-
face using two screws from Step 2.
10 Replace the top cover of the host interface.
6
5
8
APOGEE ELECTRONICS
9
9
34
Symphony 32 PCI card – User's Guide
Declarations of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause unde-
sired operation.
This equipment has been tested and found to comply with the limits of a Class A digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful inteference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the following measures:
1. Re-orient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a different circuit from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help.
NOTE: The use of non-shielded cable with this equipment is prohibited.
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user's authority to operate the equipment.
Apogee Electronics Corporation, Betty Bennett, CEO.
Industry Canada Notice
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equip-
ment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règle-
ment sur le matérial brouilleur du Canada.
Declaration of Conformity – CE
Apogee Electronics Corporation hereby declares that the product, the Symphony PCI card, to which
this declaration relates, is in material conformity with the following standards or other normative docu-
ments:
• EN 55022-1:1998
• EN 55024-2:1998
Declaration of Conformity – Japan
Apogee Electronics Corporation hereby declares that the Symphony PCI card, to which this declara-
tion relates, is in material conformity with the VCCI Class A standard.
Declaration of Conformity – Australia
Apogee Electronics Corporation hereby declares that the Symphony PCI card is in material confor-
mity with AN/NZS standard requirements.
APOGEE ELECTRONICS
35
Advertisement
Table of Contents
