AOpen i855GMEm-LFS Manual page 51

Power ON Function:
Any Key: This function allows you wake up the system by clicking any
key.
Button Only: Disable Wake on KB/MS function. You can boot up your
system by power button only.
Keyboard 98: If selecting this option, you can boot up the system by
power button and the "Wake" key on Keyboard 98.
Password: Disable the function of power button and let the system can
only be powered on through the preset keys (like a password).
Hot Key: If selecting this option, you also need to specify the hot key
from "Hot Key Power On" item.
Mouse Left: This function allows you wake up the system by clicking left
mouse button twice successively.
Mouse Right: This function allows you wake up the system by clicking
right mouse button twice successively.
Note:
Whenever you change this item, it will only take effect after you
restart the system and successfully boot the Windows or DOS.
Wake on Mouse function applies to PS/2 mouse only.
If you set a password but forget it, please clear CMOS.
If you want to use Wake on Mouse function in DOS, it is necessary to
install the DOS driver of the mouse.
KB Power ON Password: You can specify 1-5 keys as a password.
Hot Key Power On: If you select "Hot Key" option in "Power On Function"
Item, you need to specify a hot key here.
Onboard FDC Controller: Setting this parameter to "Enabled" allowing you
to connect your floppy disk drives to the onboard floppy disk connector
instead of a separate controller card. Change the setting to Disabled if you
want to use a separate controller card.
Onboard Serial Port 1: This item allows you to assign address and interrupt
for the board serial port. The default is "Auto".
Onboard Serial Port 2: This item allows you to assign address and interrupt
for the board serial port. The default is "Auto".
UART Mode Select: This item is configurable only if the "Onboard Serial Port
2" is enabled. This allows you to specify the mode of serial port2. Available
options:
Normal: Sets serial port 2 to operate in normal mode. This is the default
setting.
IrDA (SIR): This setting allows infrared serial communication at a
maximum baud rate of 115.2K baud.
This item is used to select Wake on Keyboard/Mouse mode.
51