Nokia E61 User Manual page 61

3. Define the following settings.
Connection name — Enter a descriptive name for
•
the connection.
Data bearer — Select
•
Access point name — Enter the name for the
•
access point. The name is usually provided by
your service provider or network operator.
User name — Enter your user name if required
•
by the service provider. User names are often
case-sensitive and provided by your service
provider.
Prompt password — Select
•
password each time you log into a server or
to save the password in your device memory and
automate the login.
Password — Enter your password if required by
•
the service provider. The password is often case-
sensitive provided by the service provider.
Authentication — Select
•
your password encrypted or
password encrypted when possible.
Homepage — Enter the Web address of the page
•
you want to display as a home page when you
use this access point.
4. After defining the settings, select
Advanced settings to define the advanced settings
or Back to save the settings and exit.
For information on the advanced settings, see the
extended user guide on the Web.
Packet data.
Yes to enter your
No
Secure to always send
Normal to send your
Options
>
Set up an Internet access point for
wireless LAN
1. Select Menu Tools Settings
> >
points.
2. Select Options New access
>
existing access point as a basis for the new one,
select Use existing settings. To start with an empty
access point, select Use default
3. Define the following settings.
Connection name — Enter a descriptive name for
•
the connection.
Data bearer — Select
•
WLAN netw. name — To enter the service set
•
identifier (SSID), that is, the name that identifies
the specific wireless LAN, select
To select the network from the wireless LANs in
range, select Search for
Network status — Select
•
you are connecting to is hidden, or
not hidden.
WLAN netw. mode — If you select
•
Infrastructure, devices can communicate with
each other and with wired LAN devices through
a wireless LAN access point. If you select Ad-hoc,
devices can send and receive data directly with
each other, and no wireless LAN access point is
needed.
WLAN security mode
•
security mode that is used in the wireless LAN
access point. If you select WEP (wired equivalent
privacy), 802.1x, or WPA2 (Wi-Fi protected
access), you must also configure the relevant
Connection Access
> >
point. To use an
settings.
Wireless LAN.
Enter manually.
netw..
Hidden if the network
Public if it is
— You must select the same
61