Table of Contents
Advertisement
TSU ACE User Manual
DTE TX CLK
Controls the clock used by the TSU ACE to accept the transmit (TX) data from the
DTE. Most applications will allow for this to be set to
cable is long (causing a phase shift in the data) the clock can be selected as
(Internal/Inverted - the factory default setting). This switches the phase of the clock
which should compensate for a long cable.
The
DTE device to the TSU ACE and set the proper phase of the clock. This feature
automatically selects between the
provides a clock with TX data, the clock selection is set to
depends on an externally supplied clock to accept the TX data.
Choices: INT-INV, INTERNAL, EXTERNAL, AUTO
START CHAN
Sets the starting channel for the T1 stream. This setting must be consistent with the
carrier if using a public network.
Choices: 01 through 24
# OF CHAN
Sets the number of DS0s (channels) to be used. The corresponding DTE rate will be
this number times 56K or 64K, depending on
Choices: 01 through 24
DATA
Controls the inversion of DTE data. This inversion can be useful when operating
with an HDLC protocol. Often used as a means to ensure ones (1s) density.
TSU ACEs on both ends must have identical option settings.
Choices: NORMAL, INVERT
CTS
Clear To Send - signal sent from the receiving station to the transmitting station that
indicates it is ready to accept data
Choices: FORCE ON, NORMAL (see Table 5-2 on page 42)
DCD
Data Carrier Detect - Indicates to the DTE when a valid signal is being received at
the Network Interface.
Choices: FORCE ON, NORMAL (see Table 5-2)
DSR
Data Set Ready - Indicates to the DTE when the DCE is turned
operations.
Choices: FORCE ON, NORMAL (see Table 5-2)
61202295L1-1A
setting allows the TSU ACE to automatically detect the delay from the
A
UTO
© 2003 ADTRAN, Inc.
I
NTERNAL
and
settings. If the DTE
I
I
-I
NTERNAL
NT
NV
1)R
56/64
ATE
Chapter 5 Config Menu
. If the interface
I
-I
NT
NV
. The TSU ACE
E
XTERNAL
.
O
and ready for
N
41
Advertisement
Table of Contents
