Installing The Nic; Accessing The Printer Controller Board - NEC SuperScript 1800 Network User's Manual

I
NSTALLING THE
Installing the NIC involves first accessing the printer
Controller Board.

Accessing the Printer Controller Board

The printer Controller Board manages and controls all
printer functions. It is also the place where the NIC is
installed.
To access the Controller Board:
1. Turn off the printer.
2. Pull out the 500-sheet Cassette tray (A).
3. Disconnect all cables from printer.
4. Position the printer so the right side of the printer can be
worked on.
5. Remove screws from the side cover then open
back cover (B).
Accessing the Printer Controller Board
A
D
10 SuperScript 1800 — Network User's Guide
NIC
B
E
6. Pull tab to release the side cover (C).
7. Slide side cover towards the back of the printer (D).
8. Rotate the side cover away from printer (assure wire-
snaps on the parallel port are not in the way), then lift the
side cover away (E).
9. Loosen top screw of controller board cover, remove
remaining 4 screws, then remove the metal cover (F).
When finished with Step 9, continue at "NIC Installation" on
page 11.
C
F