Miele T 650 C Operating Instructions Manual page 27

What to do if . . .
. . . drying process goes on
too long.
. . . water droplets appear at
the upper edge of the drum
aperture.
. . . water leaks from the
machine after the condenser
unit has been cleaned.
. . . the ring around the pro-
gramme selector switch is not
lit up.
. . . the interior drum lighting
does not come on.
. . . you need to open the door
during a power cut.
Cause . . .
Ventilation to and from the dryer
is insufficient (eg in a small
room). This could cause the
room temperature to rise sharply.
The vent below the door is
blocked.
The dryer cannot blow air out
correctly.
The laundry was not sufficiently
spun.
A double filter system with dual
insulation prevents fluff from
being deposited in the
condenser unit. This insulation
can lead to a build-up of
condensation.
The condenser unit has not
been correctly locked into place.
This is not a fault.
It only lights up when the
machine is switched on. The
bulb may be defective.
Problem solving guide
Remedy . . .
Open a door or window while
the machine is in operation for
increased air flow.
Remove any objects that are
blocking the vent below the
door.
–
Clean the fluff filters in the
door and the door opening.
–
Clean the condenser unit.
Spin the laundry in the washing
machine at the highest possible
spin speed.
Laundry being removed from
the machine may come into
contact with these water
droplets, but they will dry off in
a matter of minutes.
Ensure that the condenser unit
and cover are firmly in position
and lock into place again.
See the section on "Guide to
the appliance".
Change the bulb. See
instructions at the end of this
section.
See instructions at the end of
this section.
27