Miele Allerdry T 4464 C Operating Instructions Manual page 16

How to dry correctly
G Start the programme
^ Press the Start button.
– The indicator light for the Start button
will then change from flashing to
being on constantly. The drying cycle
begins.
– Depending on the programme
selected, the drying stage reached is
shown by the sequence indicator
lights on the right hand side of the
control panel.
– The allerdry sequence indicator light
will flash during an allerdry
programme to indicate that the
allerdry drying part of the
programme is in progress.
Before the end of a programme
The cooling down phase takes place
before the end of a programme so that
the garments are not too hot to handle
(the Cool air indicator light will come
on). The programme is not finished until
the cooling down phase is complete.
The Woollens hand care and
Smoothing programmes do not include
a cooling down phase.
The allerdry sequence indicator light
will come on when an allerdry
programme is selected.
At the end of a programme
The sequence indicator lights for the
drying stage reached and
Anti-crease/Finish will come on. 0 will
appear in the display.
The drum will continue to rotate at
intervals to prevent laundry creasing, if
you do not wish to remove it immediate-
ly (anti-crease). The anti-crease phase
lasts for an hour.
16
H Remove the laundry
^ Press the Door button and open the
door.
Tip for allergy sufferers:
You can use a vacuum cleaner to
remove fluff from the fluff filters in the
door opening before you remove the
laundry from the dryer. This will avoid
your skin or the laundry coming in
contact with the fluff.
^ Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^ Switch the dryer off by pressing the
l-On/0-Off button.
^ Clean the fluff filters in the door and
the door opening after each drying
programme.
^ Close the door.
^ Empty the condensed water
container (where there is no external
drainage of the water).
^ The condenser unit should be
checked and cleaned on a regular
basis.
Check lights
... See "Problem solving guide" for
details.