Miele G 673 Operating Instructions Manual page 68

Installation
Opening the door when the fixing
bracket has been taken off:
Insert your finger into the T-shaped
opening of the door opener and pull
the door open.
Dimension "X" must be calculated and
noted before attaching the fixing
bracket.
Dimension "X" is the distance shown
on the illustration between the drill hole
in the machine outer door panel and
the lower edge of the neighbouring
unit door(s).
Push the dishwasher into the recess
and adjust the height.
Calculate dimension "X".
68
Fitting the fixing bracket to a door
front
Lay the door front with the rear side
facing upwards. Draw a vertical line
down the middle of the door front
rear to use as a guide line.
Mark the dimension "X" over on to
the rear of the door front, up from the
bottom edge.
With two-piece panels:
If the two-piece panel is joined by non-
flush fixings these must be removed.
The fixing bracket supplied with the
dishwasher can be used to secure
both pieces.
Make sure that the combined height
worked out is retained.