Vivitar ViviCam 46 User Manual page 6

Powering the Camera ON
1) Batteries
Slide the front cover of your camera towards the right to reveal and open the battery
compartment.
Make sure to properly insert the batteries into your digital camera, according to the polarity
shown inside the battery compartment.
Use 2 x AAA (1.5V) batteries. Alkaline batteries are recommended. (Batteries not included.)
Place the camera front cover on the front of the camera and slide the camera front cover
towards the left to securely close the cover back into place. A click will be heard once the
camera front cover has been locked into place.
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some features will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.

Rechargeable batteries not recommended.

The energy status of the power is displayed on LCD as shown below:
Full battery power
2) SD Card
Make sure an SD card has been properly inserted into your camera. (SD card not included.)
To properly insert the SD Card:
Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD
card slot). Push the SD card until you hear a slight clicking sound. This indicates the SD
card has been inserted correctly.
Medium battery power
5
Low battery power