Short; Low Temperature; Buzzer; Start The Programme - Miele T 253 C Operating Instructions Manual

For drying fabrics which can
withstand high temperatures, e.g.
pure linens and cottons. Do not use
on minimum iron or delicate fabrics.
– Because the heater rating is
increased clothes dry faster thus
shortening drying times.
For drying delicate fabrics with the
symbol r (e.g. acrylic garments) at a
lower temperature.
– Because the heater rating is reduced
clothes dry more slowly thus
lengthening drying times.
An audible tone sounds repeatedly at
the end of a programme.
The buzzer can be switched on or off
after a programme has started.
The volume (and pitch) of the buzzer
can be adjusted before a programme is
started:
^ Select the programme.
^ Press the Buzzer button (the Buzzer
indicator lamp will light up), until the
desired volume / pitch is achieved.
Then release the button.
E
^ Press the START button.
The drying cycle begins.
16
The drying stage reached is shown by
the sequence indicator lamps on the
right hand side of the control panel.
At the end of the drying phase, a
cooling down phase commences to
cool the laundry down (the Cool air
indicator lamp lights up).
The drying level required has now been
reached.
F
When the drying programme has
finished the Anti-crease / finish
sequence indicator lamp will come on
and the buzzer will sound.
^ Press the Door button and open the
drum door.
^ Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^ After every cycle remove the fluff
from the fluff filter in the door and in
the door opening (see "Cleaning and
Care").
^ Empty the condensed water
container (where there is no external
drainage of the water).
^ The condenser unit should be
cleaned on a regular basis (see
"Cleaning and Care").
^ After each use, switch the dryer off
by pressing the l-On / 0-Off button.
^ Always close the door after use.