Check And Fault Indicator Lamps - Miele T 230 C Operating Instructions Manual

Problem solving guide
Problem
The condenser unit
service panel will not
shut.
Water leaks from the
machine after the
condenser unit has
been cleaned.

Check and fault indicator lamps

Problem
The Empty out
container indicator
lamp comes on.
The programme has
been interrupted, the
indicator lamp for
Hand iron or Machine
iron is flashing, and
the buzzer sounds.
26
Possible cause
The inner cover of the
condenser unit has not
been locked properly
and/or the condenser
unit has not been
positioned correctly.
Fluff has collected at
the bottom of the
condenser unit housing.
Possible cause
The condensed water
container is full or there
is kink in the drain hose.
There is no obvious
cause.
Remedy
– Ensure that the condenser
unit is positioned correctly
and lock the cover.
– Check the rubber seals.
– Use a cloth to remove any
fluff from the inside of the
condenser unit housing.
Remedy
– Empty out the condensed
water container.
– Check the drain hose.
– Before starting a new
programme, first switch the
dryer off and then on again.
– Switch off the dryer.
– Then switch the dryer back
on and start the programme
again.
If the programme stops again
and an indicator lamp flashes,
there is a fault. Contact the
Miele Service Department.