Miele DA 289-4 Operating And Installation Manual
Cooker
Hide thumbs
Also See for DA 289-4:
- Operating and installation instructions (36 pages) ,
- Operating and installation manual (36 pages) ,
- Install manual (1 page)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 289-4
Summary of Contents for Miele DA 289-4
- Page 1 Operating and installation instructions Cooker hood DA 289-4, DA 289-4 EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ - Page 3 Contents Operation with DSM 400 control module ......35 Potential free connection ......... 35 Connection to a light switch .
-
Page 4: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 5: Warning And Safety Instructions
Any other usage is not supported by requirements. Inappropriate use the manufacturer and could be can, however, lead to personal injury dangerous. Miele cannot be held liable and damage to property. for damage resulting from incorrect or improper use or operation. -
Page 6: Technical Safety
Faulty components must only be the appliance could be damaged. replaced by genuine Miele original Consult a qualified electrician if in any parts. The manufacturer can only doubt. guarantee the safety of the appliance... - Page 7 These models may only be combined with a Miele external motor. This appliance must not be used in a non-stationary location (e.g. on a ship). Great care should be taken when...
- Page 8 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heating appliance are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 9: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... -
Page 10: Correct Installation
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use. -
Page 11: Modes Of Operation
Modes of operation The cooker hood works with . . . air extraction: . . . an external fan: ( ...EXT models only) The air is drawn in through the vapour plate, cleaned by the grease filter and The ...EXT models are designed to be directed outside. -
Page 12: Guide To The Appliance
Guide to the appliance... - Page 13 Guide to the appliance Extension piece Tower Canopy Touch controls Hob lighting Grease filter Vapour plate Touch control for the hob lighting This control switches the lighting on and off, and is also a dimmer switch. On/Off touch control for the fan Touch controls to select fan power level Touch control for the run-on...
-
Page 14: Miele|Home
Miele electric of the cooker hood. hob with onset controls. This module must be installed by a... -
Page 15: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off control. ^ To set this option, both the fan and The fan runs at power level "II". -
Page 16: Run-On Option
Operation Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air. I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15... -
Page 17: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to ^ Pressing the On/Off control will switch on the hob lighting. -
Page 18: Filter Operating Hours Counter
Operation Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. One or more of the indicator lamps for the – /+ controls will flash. The number of flashing lamps shows the percentage of the operating time The indicator lamp for the grease filter which has already been used up. -
Page 19: To Alter The Filter Operating Hours Counter
Operation To alter the filter operating hours counter This can be lengthened or shortened to suit the type of cooking you do. The – /+ control lamps show the time You can choose from 20, 30, 40 or 50 which has been set: hours. - Page 20 Operation If the indicator lamp for the grease filter control turns blue during operation, this indicates that unrequired electronics have been activated inadvertently. To deactivate: – With the fan switched off, press the + control and the grease filter control at the same time.
-
Page 21: Cleaning And Care
(This infomation does not apply to the controls). Housing Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a General notes proprietary non-abrasive cleaning agent designed specifically for use on The surfaces and controls are stainless steel. -
Page 22: Vapour Plate And Grease Filter
Cleaning and care Vapour plate and grease filter Important for appliances with lacquered housing The vapour plate and the re-useable (special order finish) metal grease filter remove solid particles from the kitchen vapours It is very difficult to clean this type of (grease, dust, etc), preventing soiling of surface without causing minor marks to the cooker hood. - Page 23 Make sure that the spray arm can move freely. ^ Do not wash at more than 65° C. If a Miele dishwasher is being used, select the Sensor wash programme. ^ Use a mild dishwasher detergent. ^ Pull the grease filter by the hand-hold Depending on the cleaning agent forwards and out.
- Page 24 Cleaning and care ^ When cleaning the vapour plate, please follow the instructions given under "Housing" earlier in this section. ^ With the vapour plate and grease filter removed, clean off any residues of oil or fat from the now accessible housing and channel on the lower housing to prevent the risk of these catching fire.
-
Page 25: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them. -
Page 26: Appliance Dimensions
Appliance dimensions The diagram is not drawn to scale. -
Page 27: Safety Distance Between Hob And Cooker Hood (S)
Appliance dimensions The shaded areas 1) and 2) represent the wall or ceiling area for the vent cut-out, for fitting the connection socket and, in the case of EXT models, for feeding the connection cable through to an external fan. Connection for air extraction C 150 mm, or C 125 mm with reducing collar. -
Page 28: Installation
Installation Assembly parts... - Page 29 Installation 3 protective sheets for use when fitting the tower. Upper retaining plate 6 screws 3.5 x 9.5 mm for securing the extension piece. for securing the canopy and the filter housing Middle retaining plate for securing the extension piece. 1 exhaust connection for exhaust ducting C 150 mm.
-
Page 30: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as Appliance dimensions and the described on the installation sheet. -
Page 31: Connection For Air Extraction
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as... -
Page 32: Condensate Trap
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. -
Page 33: Silencer
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the fan, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to where the ducting leaves the building ...air extraction with external motor: To minimise noise from the motor in the... -
Page 34: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 35: Operation With Dsm 400 Control Module
Operation with DSM 400 control module The Miele DSM 400 control module can Components used in the central be used to combine the cooker hood ducting system are not supplied by with other components. Miele. It enables the following: If in any doubt, the advice of a... -
Page 36: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –... -
Page 37: Technical Data
Length of connection cable to external DA 289-4....33 kg motor..... . . 1.9 m... - Page 40 Alteration rights reserved / 3011 M.-Nr. 09 200 160 / 00...