Advertisement
Installation Instructions For Windows XP
PLEASE NOTE: do not connect your ProjectMix I/O to your computer until the
appropriate driver files have been copied. Be sure to leave your ProjectMix I/O disconnected
until instructed to connect it below.
1.
Insert the FireWire Driver CD-ROM into your computer's CD-ROM
drive.
2.
The computer will automatically display the interactive install screen
shown in picture
. If your computer fails to launch the installer, manually
start the installer by clicking on Start>My Computer>FireWire Series.
3.
Select ProjectMix I/O from the drop-down menu and click "Install" to
begin copying files.
4.
Follow the driver installer's on-screen direction prompts.
5.
At various points in this installation process, you may be notified that
the driver being installed has not passed Windows Logo Testing. Click
"Continue Anyway" to proceed with the installation.
6.
Once the driver installer has completed the installation, shut down your
computer.
7.
After your computer has turned off, you may connect your ProjectMix
I/O to an available FireWire port using the cable provided. You will also
need to connect the included power supply to provide power to the
unit.
8.
Turn on the ProjectMix I/O first, then turn on your computer.
9.
When Windows boots up, it will identify the ProjectMix I/O. You will be
asked if you want to search the Internet for a driver. Select "No, not this
time" and press "Next" (
10. Windows will display a "Found New Hardware" Wizard like the one
seen in picture
.
11. Choose "Install the software automatically" and click "Next."
12. Once the Wizard is completed, click "Finish."
13. A pop up message will appear briefly that says "Your new hardware is
installed and ready to use."
Installation Instructions For Mac OS X
PLEASE NOTE: do not connect your ProjectMix I/O to your computer until the
appropriate driver files have been copied. Be sure to leave your ProjectMix I/O disconnected
until instructed to connect it below.
1.
Insert the FireWire Driver CD-ROM into your computer's CD-ROM
drive.
2.
Double-click the CD icon when it appears on your desktop to view the
contents of the CD.
3.
Double-click the "Open Me" icon to launch the driver selector shown
in picture
.
4.
Select ProjectMix I/O from the drop-down menu on the welcome
screen then click "Install."
5.
The driver installer will launch. Follow the on-screen direction
prompts (
).
6.
When the installer has finished the installation, shut down your
computer.
7.
After your computer is off, connect the ProjectMix I/O to your
computer's FireWire port and the included power supply to a power
outlet, then power the ProjectMix I/O on.
8.
Turn on your computer. When the computer has fully booted, your
ProjectMix I/O will be ready to use.
ProjectMix I/O Quick Start Guide
).
1
English
Advertisement
