Preparations; Adapter From The Outlet - Zoom UIB-01 Installation Manual

Preparations

This section describes how to install the UIB-01 in the MRS-1044, and
how to install the driver software on the computer. These steps are
required before the UIB-01 can be used.
Installing the UIB-01
The UIB-01 is designed for installation in the side panel slot of the MRS-
1044.
Before installing the UIB-01 in the MRS-1044, be
sure to turn the MRS-1044 off and disconnect the
Warning
AC adapter from the outlet.
1.
Remove the two screws that fasten the cover of the side
panel slot, and remove the cover.
These screws will be used to fasten the UIB-01.
6 ZOOM UIB-01
2.
With the populated side of the UIB-01 board (the side with
IC chips and other components) facing downwards, push
the UIB-01 fully into the slot.
Align the board with the rails of the slot, and make sure that it clicks
into place. If the board does not go all the way in, check whether the
UIB-01 has not been inserted upside down, and whether it is
properly aligned with the rails.
3.
Use the screws removed in step 1 to fasten the UIB-01.
Correct
Incorrect
ZOOM UIB-01 7