Yamaha PM1D Supplementary Manual page 32

PM1D System Software V1.6 Supplementary Manual
You can also hold down the top panel [SHIFT]
switch and press the METER section METER
SELECT [MIX 25-48] switch or [MATRIX 1-24]
switch to make the meter bridge show the input lev-
els of the input channels. In this case as well, only the
METER SELECT [MIX 25-48] switch will blink, and
the above button will automatically be turned
on.
At this time, the MIX/MATRIX bus number LED in the lower part of the meter bridge will go dark.
button
The same display will appear as when the ST IN button is turned on in FIXED CH mode.
button
The same display will appear as when the MIX button is turned on in FIXED CH mode.
button
The same display will appear as when the MATRIX button is turned on in FIXED CH mode.
While the meter bridge shows the input channel or ST IN channel levels, the panel switches in the METER section
will operate differently, as follows.
The METER [PRE] switch cannot be operated. However if PRE ATT/PRE GATE / PRE FADER is selected as the
metering point, the METER [PRE] switch LED will blink.
While the METER screen IN PEAK HOLD button is on, the METER [PEAK HOLD] switch LED will blink.
32
SHIFT
+
or
SHIFT
+