System Update Procedure; Updating The Firmware (Cs1D/Dsp1D(-Ex)/Ai8/Ao8/Dio8) - Yamaha PM1D v.2 Installation Manual

INPUT/OUTPUT UNIT section
Only that unit is muted, and will not be
INPUT UNIT not OK
controllable
Only that unit is muted, and will not be
OUTPUT UNIT not OK
controllable
CONSOLE section
INPUT01-12 not OK INPUT block (CS1D lower left) inoperable
INPUT13-24 not OK INPUT block (CS1D upper left) inoperable
INPUT25-36 not OK INPUT block (CS1D lower right) inoperable
INPUT37-48 not OK INPUT block (CS1D upper right) inoperable
SELECTED INPUT CHANNEL block
INSEL not OK
inoperable
MAS1 not OK MIX OUTPUT / DCA GROUP block inoperable
MAS2 not OK MIX OUTPUT / DCA GROUP block inoperable
SELECTED OUTPUT CHANNEL block,
SCENE MEMORY block, MASTER block, LCD
FUNCTION ACCESS block, USER DEFINE
OUTSEL not OK
block, STEREO OUTPUT block, Data entry
block (except for track pad and left/right
switches) inoperable
METER not OK METER BRIDGE block will not function
The system will recover from these limitations when you remove
the cause of the problem and turn on the power of the CS1D
once again.
NOTE:
• These problems can normally be solved by executing the system
update described below. However, if problems remain after this is
done, please contact Yamaha service.
• If there is a problem with a unit, please check whether there is a
faulty connection for the D-Sub half-pitch 68-pin cable. The unit
will not function correctly if a pin is bent or not inserted.

System update procedure

When updating the system, you must perform the update and
installation for all components. Using the procedure described
below, perform the firmware update and the CS1D screen
software update.
Scene data etc. that you created using this system must be
backed up on a memory card before you perform the update.
The internal data will be lost when you perform the update
procedure.
For details on how to save data to a memory card, refer to
the Reference Manual (Software).
4
Updating the firmware (CS1D/
DSP1D(-EX)/AI8/AO8/DIO8)
You will use the PM1DLOAD software to update the firmware of
each component. The basic procedure and the update method
for each firmware is explained below.
[Explanation of each screen in PM1DLOAD]
A
B
4
6
C
D
E
F
G
H
I
PM1D V2 System Software Installation Guide
Mode Select screen
1
2
"Write via serial port" mode
You must select this.
"Write board directly" mode
Do not select this.
Main screen
3 7 8
K L
[Setup] menu
select the computer's serial port (only ports
Serial Port
1–9 are supported) to use
select the serial port (only ports 1–9 are
Connection Point
supported) to use on the PM1D system
Fonts change the display font
Target select menu ...................specify the component to be
Overall version .........................indicates the version to be
Writing target check boxes ......check boxes select writing
ROM version field ....................indicates the currently-
File version field .......................indicates the version to be
[GetVer.] button .......................obtains the ROM version
5
9
J
written
written (overall version)
target
written version
written