Display Messages; Error Messages; Warning Messages - Yamaha DME4io-C Owner's Manual

References

Display Messages

The [ERROR] and [PEAK] indicators on the front panel of the DME Satellite indicate error and warning messages.

Error Messages

Indicator
Flashing
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Flashing
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Flashing
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Flashing
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Flashing
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Flashing
PEAK PEAK
Lit
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL

Warning Messages

Indicator
Flashing
PEAK
SIGNAL
rapidly
PEAK
SIGNAL
Flashing PEAK
SIGNAL
slow
PEAK
SIGNAL
Error
A system error has occurred.
PEAK
SIGNAL
PEAK
SIGNAL
Data inside the internal flash
memory has been erased.
PEAK
SIGNAL
PEAK
SIGNAL
The internal battery is
completely discharged or not
PEAK
installed.
SIGNAL
PEAK
SIGNAL
A scene recall attempt has
Flashing
failed.
PEAK
SIGNAL
PEAK
SIGNAL
Audio is not input or output and
PEAK
is muted due to insufficient DSP
SIGNAL
resources.
PEAK
SIGNAL
The network is not
PEAK
communicating properly.
SIGNAL
PEAK
SIGNAL
Duplicate IP addresses.
PEAK
SIGNAL
PEAK
SIGNAL
The DME Satellite contains data
PEAK
for a different device group or
SIGNAL
no data.
PEAK
SIGNAL
Flashing
Error
The internal battery is almost
PEAK PEAK
discharged. Your data may be
SIGNAL SIGNAL
lost.
PEAK PEAK
SIGNAL SIGNAL
The backup battery voltage is
PEAK PEAK
low.
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Action
Execute the "Initialize DME" operation, then restart it. If the error
indicators are still indicating the error, execute the "Delete All Data"
initialization. If the problem persists, contact a Yamaha dealer.
The firmware update operation may have failed. Use DME Designer
to execute the Recovery update operation. If the problem persists,
contact a Yamaha dealer.
If you turn off the power to the unit, the current settings will be lost
and reset to the default values. Stop operating the unit, and contact a
Yamaha dealer regarding battery replacement.
Use DME Designer to recall the scene again.
If the problem persists, contact a Yamaha dealer.
This error sometimes occurs if you try to operate a configuration at 96
kHz that has been created with a word clock of 48 kHz. To operate a
configuration at any word clock setting, use DME Designer to create
a configuration with the word clock set to 96 kHz.
Connect the network cables properly, and make sure that the
network devices are operating correctly.
Connect your computer to the DME Satellite via USB, then set a
unique IP address.
Send data appropriate for the actual device configuration from DME
Designer.
Action
If you turn off the power to the unit, the current settings may
be lost and reset to the default values. Stop operating the
unit, and contact a Yamaha dealer regarding battery
replacement.
This does not affect the operation of the unit. However, if you
continue using the unit, the settings may be lost and reset to
the default values. Contact a Yamaha dealer regarding
battery replacement at your earliest convenience.
DME8i-C/DME8o-C/DME4io-C Owner's Manual
39