Table of Contents
Advertisement
Resetting the Terminal
There are two types of system resets: a soft and a hard reset.
Soft Reset (Warm Boot)
A soft reset re-boots the device without losing RAM data. You would perform a soft reset when
• the terminal fails to respond.
• after installing some software applications.
• after making changes to certain system settings, such as network cards.
1. Press and hold the RED
2. The decode and scan LEDs flash for approximately three seconds as the terminal resets.
3. When the reset is complete, the Today screen displays.
Hard Reset (Cold Boot)
A hard reset resets the operating system, restores the terminal back to factory defaults, and resets the
terminal after a bootloader, keyboard, and kernel upgrade.
A hard reset erases all of the data stored in RAM memory and all RAM installed applications!
1. Press and hold the RED
2. The decode and scan LEDs light for approximately 3 seconds.
3. The terminal re-initializes; see
Suspend Mode
The terminal goes into Suspend Mode automatically when the terminal is inactive for a programmed
period of time. You can program this time on the Advance tab of the Power System Setting; see
on page
7-14.
To put the terminal into Suspend Mode manually, press the Power key
To wake the terminal from Suspend Mode, press the Power key
Hardware Maintenance
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
For additional information on hardware maintenance specific to the Dolphin Healthcare Housings,
page
3-12.
3 - 16
TAB
+ TAB
keys for approximately 5 seconds.
®
ENT
+ ENT
keys for approximately 5 seconds.
Initialize the Mobile Computer
on page
2-8.
and the screen goes blank.
SCAN
or SCAN key
Power
.
see
Advertisement
Table of Contents
