Updating The Display Receiver Firmware Only - ActionTec ScreenBeam SBWD100A User Manual

Updating the Display Receiver Firmware Only

If you are using ScreenBeam with a Miracast or Intel WiDi device, use the
following procedure to update the Display Receiver's firmware.
1. Download the latest ScreenBeam firmware at:
http://www.actiontec.com/screenbeam
2. Extract the "install.img" from the zip file.
3. Copy "install.img" file to to the root folder of a USB flash drive.
Note: Do not use a portable USB hard drive. Use a USB flash drive only.
4. Ensure that the HDTV connected to the Receiver is powered on and the
correct HDMI input is selected, then plug the USB flash drive into the USB
port on the Receiver.
5. Unplug the Power cord from Receiver.
6. Press and hold the Reset button on the Receiver with the tip of a pen.
7. While holding the Reset button, plug the Power connector into the Receiver
and wait.
8. When the Upgrade message appears on your HDTV screen, release the
Reset button.
WARNING: Do not power off the Receiver or remove USB flash drive
while the Receiver is upgrading. This may cause the firmware to fail.
9. Wait until the upgrade completes and then remove the USB flash drive.
The Display Receiver's firmware is now upgraded.
Updating Software and Firmware
20