Power; Ac Supply Wiring; Dc Supply Wiring - Siemens sitrans LU01 Instruction Manual

Power

Before making the power connection, ensure proper voltage selection.
Note:

AC Supply Wiring

voltage switch
shown in the 'OFF'
position. Select
appropriate voltage.
Notes:
• The equipment must be protected by a 15 A fuse or circuit breaker in the
building installation.
• A circuit breaker or switch in the building installation, marked as the
disconnect switch, shall be in close proximity to the equipment and
within easy reach of the operator.
• Never operate the SITRANS LU01 with the enclosure lid open, or with
the ground (earth) wire disconnected.
• Ensure that any associated alarm or control equipment is disconnected
until satisfactory operation is verified.

DC Supply Wiring

DC terminals shall be supplied from a SELV source in accordance with
Notes:
IEC-1010-1 Annex H.
7ML19985BE02
33
33 34 35 36 37
24 V
!
BOARD B
SITRANS LU01 – INSTRUCTION MANUAL
34 35
100/115/200/230 V
50 / 60 Hz
Select voltage via switch.
34 35 36 37
24 V
L1
L2/N
36 37
Page 17