Turn Signals And Headlights - Honda Automobiles 2008 CRV Owner's Manual

Turn Signal Push down on the
lever to signal a left turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Turning the switch to
Headlights
the '' '' position turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate light.
Turning the switch to the ''
position turns on the headlights. If
you leave the lights on with the key
removed from the ignition switch,
you will hear a reminder chime when
you open the driver's door.
When the light switch is in either of
these positions, the lights on
indicator comes on as a reminder.
This indicator stays on if you leave
the lights on and turn the ignition
switch to the ACCESSORY (I) or
LOCK (0) position.
Push the lever
High Beams
forward and the high beam indicator
will come on (see page
back to return to low beams.
'' To flash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.

Turn Signals and Headlights

Daytime Running Lights
With the headlight switch in the off
or position, the high beam
headlights and the high beam
indicator come on with reduced
brightness when you turn the
ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch off, even if you
set the parking brake.
63 ). Pull it The headlights revert to normal
operation when you turn them on
with the switch.
75