Table of Contents
Advertisement
Unit Object Commands
Unit Object commands provide information and perform actions related to a
specific unit, such as
logical disk object commands for such tasks as seeing the rebuild, verify, or
initialize status of a unit, starting, stopping, and resuming rebuilds and
verifies, and setting policies for the unit.
Syntax
/cx/ux show
/cx/ux show attribute [attribute ...] where attributes are:
initializestatus|name(9000 series)|
qpolicy(9550SX only)|rebuildstatus|
serial(9000 series)|status|storsave(9550SX only)|
verifystatus|volumes(9000 series)
/cx/ux show all
/cx/ux start rebuild disk=<p:-p...> [ignoreECC]
/cx/ux start verify
/cx/ux pause rebuild
/cx/ux resume rebuild
/cx/ux stop verify
/cx/ux flush
/cx/ux del [noscan] [quiet]
/cx/ux set autoverify=on|off
/cx/ux set cache=on|off [quiet]
/cx/ux set ignoreECC=on|off
/cx/ux set qpolicy=on|off
/cx/ux set name=string
/cx/ux set storsave=protect|balance|perform (9550SX only)
/cx/ux migrate type=RaidType [disk=p:-p] [group=3|4|5|6]
[stripe=Stripe] [noscan] [nocache] [autoverify]
(9000 only)
/cx/ux export [noscan] [quiet]
/cx/ux show
This command shows summary information about the specified unit /cx/ux. If
the unit consists of sub-units as with the case of RAID-1, RAID-5, RAID-10,
RAID-50, then each sub-unit is further presented.
One application of this command is to see which sub-unit of a degraded unit
has caused the unit to degrade and which disk within that sub-unit is the
source of degradation. Another application is to see the source and destination
units during a migration.
www.3ware.com
(unit 1 on controller 0). For example, you use
/c0/u1
Unit Object Commands
(7000/8000 only)
(7000/8000 only)
(9550SX only)
(9000 series)
53
Advertisement
Table of Contents
