Cli Notification; Alarm Events - Meinberg LANTIME/GPS Operating Instructions Manual

CLI Notification

Alarm events

On this page you can set up different notification types for a number of events. This
is an important feature because of the nature of a timeserver: running in the
background. If an error or problem occurs, the timeserver is able to notify an
administrator by using a number of different notification types.
The LANTIME timeserver offers four different ways of informing the administrator
or a responsible person about nine different events: EMAIL send an e-mail message
to a specified e-mail account, SNMP-TRAP sends a SNMP trap to one or two SNMP
trap receivers, WINDOWS POPUP MESSAGE sends a Winpopup message to one or
two different computers and DISPLAY shows the alarm message on a wall mount
display model VP100/NET, that is an optional accessory you can obtain from us.
"NTP not sync"
"NTP stopped"
"Server boot"
"Receiver not responding"
"Receiver not sync"
"Antenna faulty"
"Antenna reconnect"
"Config changed"
„Leap second announced"
Every event can use a combination of those four notification types, of course you can
disable notification for events by disabling all notification types. The configuration of
the four notification types can be changed in the upper section of the page, you can
control which notification is used for which event by using the button "notification
conditions" in the lower part of the page.
NTP is not synchronised to a reference time source
NTP has been stopped (mostly when very large time offsets
occur)
System has been restarted
No contact to the internal GPS receiver
Internal GPS clock is not synchronised to GPS time
GPS antenna disconnected
GPS antenna reconnected
Configuration was changed by a user
A leap second has been announced
78