Observing; Observing By Moving The Telescope Manually; Terrestrial Observing; Observing Using Audiostar's Arrow Keys - Meade StarNavigator Series Instruction Manual

Important Note: When
you look through your
telescope's eyepiece,
the image might look
strange at first.
If you have a refracting
telescope, objects will
appear right-side-up, but
reversed left-for-right.
This will not make a
difference when
observing astronomical
objects and, in fact, all
astronomical telescopes
present inverted images.
During terrestrial
observing, when a
corrected image (right-
side up and correct left-
for-right) is desirable, an
optional Meade 45°
Erecting Prism is
available. See
OPTIONAL
page 32,
ACCESSORIES,
or consult the Meade
Telescope Catalog.
No means of correcting
the image is available for
reflecting telescopes—
the image will appear
upside down and
reversed left-for-right.

OBSERVING

Observing by Moving the Telescope Manually

If you wish to observe a distant land object, such as a mountain top or a bird, you can observe
by merely pointing the telescope and looking through the eyepiece.
1. Loosen the telescope's tripod base lock knob (26, Fig. 1) and Altitude lock (10F, Fig. 1b),
so that the telescope can move freely.
2. Point your telescope at distant street signs, mountains, trees, and other structures. Use
your red dot viewfinder to help site-in on an object.
3. Centre the object using the red dot viewfinder and then in the telescope eyepiece. When
the object is centred in your eyepiece, re-tighten the base and Altitude locks.
4. Practice focusing objects with the focus knob (1, Fig. 1).
5. Once you get a feel for how your telescope moves and focuses, try to view something more
challenging, like a bird or a distant moving train.
You can also observe stars and objects in the night sky using this method, but note that objects
begin to slowly drift across the eyepiece field. This motion is caused by the rotation of the Earth.
As you become familiar with the Audiostar handbox operation, you can counteract the drift
using the automatic tracking feature in the Audiostar Setup menu (see
, page 16), or by using Audiostar's GO TO capabilities (see
AUTOMATICALLY
page 19).

Terrestrial Observing

StarNavigator refracting telescopes are excellent high-resolution, terrestrial (land) telescopes
(reflecting telescopes are designed primarily for astronomical observations). Viewing terrestrial
objects requires looking along the Earth's surface through heat waves. These heat waves often
cause degradation of image quality. Lower power eyepieces, such as a 25 mm eyepiece,
magnify these heat waves less than higher power eyepieces. Therefore, lower power eyepieces
provide a steadier, higher quality image. If the image is fuzzy or ill-defined, reduce to a lower
power eyepiece, where the heat waves do not have such an effect on image quality. Observing
in early morning hours, before the ground has built up internal heat, produces better viewing
conditions than during late afternoon hours.

Observing Using Audiostar's Arrow Keys

You may observe land and astronomical objects using Audiostar's Arrow keys to move the
telescope.
1. Tighten the Altitude lock (10F, Fig. 1b) and tripod base lock knob (26, Fig. 1).
2. Make sure the telescope power switch is in the OFF position. Plug Audiostar into the HBX
port of the Control Panel.
3. Flip the telescope power switch to the ON position.
Audiostar is activated and a copyright message displays briefly, followed by a short beep.
Then Audiostar takes a few moments to start up the system.
4. AudioStar displays "Press 0 to align or Mode for Menu." The telescope motors are now
activated and can be used to move the telescope using the arrow keys.
5. Press the Arrow keys (5, Fig. 2) to slew (move) the telescope up, down, right, or left.
6. Press a NUMBER key (6, Fig. 2) to change the telescope's slew speed. Each time you
press a number from 1 through 9, the speed will change. See
more information.
7. Use the red dot viewfinder (7, Fig. 1 or 1e) to locate an object and practice using the
Audiostar's Arrow keys to centre the object in the telescope eyepiece's field of view.
8. Use the telescope's focus knob (1, Fig. 1) to bring the object into focus.
Looking at or near the Sun will cause irreversible damage to your eye. Do not point this telescope at or near the Sun.
Do not look through the telescope as it is moving.
14
TO TRACK AN OBJECT
GO TO SATURN
, page 15, for
SLEW SPEEDS
,