Mazda 2007 Mazdaspeed 3 Quick Tips page 14

Under Hood
U N D E R H O O D
1 2 3 4 5
1110 9 8 7
2.0/2.3-liter Engine
1. Engine coolant reservoir
Level should be between COLD
FILL RANGE indicator marks
WARNING: Never remove
coolant reservoir cap while
engine is running or hot;
remove only when safe
2. Engine oil filler cap
See Owner's Manual for
recommended engine oil viscosity
Break-in period
First 600 miles: Avoid heavy
braking and acceleration; drive at
varying road and engine speeds
Tip: Follow the same procedures
with newly overhauled engine
or when brakes are replaced
Maintenance notes:
Rotate tires every 7,500
miles or sooner if needed
Replace cabin air filter every
25,000 miles or 24 months
Replace (FL22)* engine
coolant at 120,000 miles
WARNING: Using coolant other
than FL22 requires more frequent
maintenance intervals
Tip: For severe driving
conditions, Owner's Manual
recommends changing oil
and filter at 5,000 miles
†
Always check the Owner's Manual for more operating information and safety features
1 2 4
6 11 10 3 9
2.3-liter I4 Turbo Engine
3. Engine oil dipstick
Fluid should be between F and
L on dipstick; do not fill above F
4. Brake/clutch fluid reservoir
Fill to MAX mark with DOT 3
fluid; check with cap on
Tip: Clutch uses same
reservoir as brakes
5. Battery
N O R M A L S E R V I C E I N T E R V A L S
7,500 miles
A
15,000 miles A
22,500 miles
A
30,000 miles A B
37,500 miles A
45,000 miles
A
52,500 miles A
60,000 miles A B
67,500 miles A
75,000 miles A
82,500 miles A
90,000 miles A B
Tip: For additional service
intervals and complete details,
see Owner's Manual
5 6. Fuse panel
Push latch in, lift cover must
be between the indicator
marks on the dipstick
7. Air filter
8. Automatic transaxle
fluid dipstick*
Check with transaxle in park,
engine on and at operating
7 6
temperature
9. Hood latch
Press right to release hood
10. Power steering fluid
reservoir
Level should be between
MIN and MAX lines
11. Windshield washer reservoir
Fill with windshield
washer fluid
Tip: Check all fluids with
vehicle parked on a level
surface and engine off
unless otherwise stated
A. Replace: Engine oil/filter
Lubricate: All locks
and hinges
F B . Inspect: Cooling system, fuel
lines and hoses, brake lines,
hoses and connections, steering
F
operation and linkages, front
and rear suspension and ball
C
joints, drive-shaft dust boots
F G
C . Inspect: Drive belts (tension)
Replace: Air filter
D F
D. Inspect: Hoses and tubes for
emission system
Replace: Engine coolant
C E F
(Other than FL22)
E . Inspect: Engine valve clearance
F G Replace: Spark plugs
F . Inspect: Disc brakes
G . Inspect: Exhaust system and
heat shields
*Denotes optional equipment
†
See Owner's Manual