Mazda RX-8 Quick Tips page 9

Quick Tips
Manual controls
1. Fore-aft adjustment
Lift lever and hold, slide
seat, release lever
2. Raise/lower seat
Pull/push lever and release
3. Seatback angle
To adjust: Lift and hold lever, lean
forward or backward, release lever
Tip: Side-impact air bags*
deploy from outboard
side of driver and front
passenger seatbacks
WARNINGS: Do not adjust
seats while driving, you can
lose control of vehicle
Safety belts must always be
worn when vehicle is in motion
Air bags are supplemental
and do not replace safety
belt usage
Always wear your safety belt
and properly secure children
12 and under in the rear seat
Never place rear-facing
infant-safety seat in front
of any air bag, an infant is
in serious danger of being
injured or killed
If you choose to install a
forward-facing child-safety
seat in the front seating
position, move vehicle seat
as far back as possible
Always check the Owner's Manual for more operating information and safety features
2004 Mazda
3
1 2
4 5
Child-safety seat
To install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner's Manual
for proper installation and child
seat tether and LATCH system
instructions
WARNING: Use age
appropriate child restraints,
see Owner's Manual and
state or province laws
Mazda RX-8
Power driver's seat*
4. Raise/lower front of
seat cushion
Pull/push front of switch vertically
Fore/aft adjustment
Slide switch horizontally
Raise/lower rear of
seat cushion
Pull/push rear of switch vertically
5. Seatback angle
Press front/rear of switch
6. Lumbar adjustment*
Press front/rear of switch to
increase/decrease firmness
Seat warmer*,
see Console/Transmission
6
Dual locking mode
lap/shoulder belt
retractor (front passenger
and rear safety belts only)
Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about
5 mph or more
Automatic locking mode:
Must be used when installing
child-safety seat
To activate: Pull webbing until fully
extended from retractor until click
is heard; belt will only tighten
when released
To disengage: Unbuckle belt and
allow webbing to retract fully
*Denotes optional equipment
page 16
page 17