Sharp XG-V10WE Operation Manual page 50

Adjusting the Computer Images (RGB menu only)
Projector
(GUI) On-screen Display
2
3
3
47
Remote Control
1, 6
2, 3, 4
5
1.2.3 4.5.6
Saving and Selecting Adjustment Settings
This projector allows you to store up to seven adjustment
settings for use with various computers. Once these
settings are stored, they can be easily selected each
time you connect a computer to the projector.
Saving the adjustment setting
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Save Setting", and then
press ©.
4 Press ∂/ƒ to select the desired memory location
of the setting.
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
Selecting a saved setting
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Select Setting", and then
press ©.
4 Press ∂/ƒ to select the desired memory setting.
5 Press ENTER to select the setting.
6 To exit from the GUI, press MENU.
• If a memory position has not been set, a resolution and
frequency setting will not be displayed.
• When selecting the stored adjustment setting with "Select
Setting", the computer system should match the stored
setting.
MOUSE ADJ.
MOUSE ADJ.