Troubleshooting - Honda 2008 Accord Navigation Manual

Troubleshooting

Screen Error Message
Navigation system is unable to acquire a proper GPS
signal.
Navigation unit door is open or No DVD disc is
inserted. Please check system.
No DVD disc. Please check system.
DVD disc reading error (unformatted). Please consult
your dealer.
Display temp is too high. System will shut down until
display cools down.
Outside temperature is low. System will take awhile to
start up.
Route has not been completed. Please try again from a
different location.
No alternate route found. Original route will be
followed.
This destination cannot be found in database.
* If the error persists, or is shown for a wide area, see your dealer.
128 Navigation System
Make sure there is nothing on the rear shelf blocking the GPS antenna (after-
market metallic window tinting or after-market devices placed on the rear shelf like
radar detectors, cell phones, or loose items). If the rear shelf is clear of objects,
move the vehicle to an open space away from tall buildings, trees, etc.
Make sure that the navigation DVD disc is inserted with the label side up and the
navigation unit door is fully snapped closed (see page 109).
Check that the navigation DVD disc is inserted with the label side up (page 109). If
the problem persists, see your dealer.
Check the DVD disc surface for deep scratches or other damage. Make sure you are
using a Navigation DVD (white colored label). The system cannot read other
mapping databases or video DVDs. If the problem persists, see your dealer.
This message will appear briefly when the display temperature is too high, and then
the display will turn off until the temperature cools down. The system will turn
back on when the display cools down.
The temperature is below -22°F and the navigation ECU has difficulty reading the
DVD. The system will start up when the temperature warms up.
This message will appear when you are routing to or from a place (new area) that is
not in the database. Try planning a different route to or from a different location.*
No alternative route method was found. The original route method will be used.*
Ensure that a road name is displayed at the bottom of the map.
The destination was not found in the database. Try another destination nearby, or
select the destination with the Interface Dial.*
Solution