Marshall Amplification JVM410HJS Joe Satriani Owner's Manual page 9

Hide thumbs

Table of Contents

Control Change

Program Change

* EUROPE ONLY

- Note: This equipment has been tested and found to comply with the requirements of the EMC Directive (Environments E1,

E2 and E3 EN 55103-1/2) and the Low Voltage Directive in the E.U.

* EUROPE ONLY - Note: the average half-cycle r.m.s. inrush current, on initial switch-on, is 5.4 amps

the average half-cycle r.m.s. inrush current after a supply interruption of 5 s is 5.1 amps

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

JVM MIDI IMPLEMENTATION

FUNCTION

VALUE

3-127

2-127

0-127

Follow all instructions and heed all warnings