Table of Contents
Advertisement
CS68 ECDIS
Note
Note
8
Chart Interface unit
The Chart Interface unit is preferred to be mounted vertically.
Make sure that the mounting location for the unit allows for
cable entry. Refer dimensional drawing on page 73.
The Chart Interface unit is secured to the bulkhead with four
screws.
Loudspeaker
The speaker included in the CS68 system is design for panel
mounting. A mounting kit including screws and front panel
corners is included with the speaker.
1
Drill the mounting holes and make a panel cut-out
according to dimensional drawing, page 71.
2
Use the supplied screws to fasten the speaker to the panel.
3
Apply the front panel corners.
Alarm reset unit
The Alarm Reset unit is used in different chart systems, and it is
therefore delivered with different text stickers to match the
system.
If the Alarm Reset unit is used in an ECDIS system, the
sticker should be used. If used in an ECDIS back-up system, the
sticker is to be used.
CS68
Use the following procedure when mounting the Alarm reset
unit:
1
Fix the
ECDIS
Note above.
2
Attach the lid to the button, and press firmly.
3
Drill the mounting holes according to the dimensional
drawing or drilling template on page 74 and page 81.
4
Fasten the Alarm Reset unit to the panel with the supplied
mounting screws.
Cherry keyboard and TrackMan® wheel
The Cherry keyboard and the TrackMan wheel may be fixed to
the desk by using the included Velcro fasteners.
To fulfill the ECDIS regulations, the Cherry keyboard and the
TrackMan wheel must be mounted in an illuminated location!
or the
sticker to the button. Refer
CS68
ECDIS
20221933 / E
Advertisement
Table of Contents
