Help With Setup - Logitech K700 Setup Manual

Logitech® Keyboard Controller

Help with setup

Problem: My Keyboard Controller does not work or will not connect.
Solution: Check the following:
• Is the Keyboard Controller on? The ON/OFF power switch must be set to ON. If it is, turn the
power switch OFF and then ON. The power LED above the Touchpad should light green, or red
if the batteries are low in power.
• Are the batteries installed properly? Remove the battery cover and check battery installation.
Refer to page 9 for more information.
• Is your Keyboard Controller paired with the Logitech Revue™ Companion Box (sold separately)?
To pair the Companion Box with the Keyboard Controller, turn on the Keyboard Controller. Press
and release the button located on the back of the Logitech Revue Companion Box under the
Unifying logo. Now, turn the keyboard power switch OFF and then ON. Refer to page 7 for
more information.
• Is your Keyboard Controller paired with a Google TV – based smart TV system? Make sure
the Unifying receiver is plugged into a USB port on your Google TV. Try using the USB cable
extender to place the Unifying receiver farther away from your TV, which may be producing
electromagnetic interference. Refer to page 6 for more information. You may need to re-
establish the connection between the Keyboard Controller and its Unifying receiver:
1. Insert the Unifying receiver in a USB port on a PC that is connected to the Internet.
2. Download the Unifying software from www.logitech.com/unifying.
3. Follow the on-screen instructions to reconnect the Keyboard Controller with the
Unifying receiver.
4. When finished, insert the Unifying receiver back into a USB port on the TV. The connection
between the Keyboard Controller and Unifying receiver should now be re-established.
10
Problem: In a Logitech Revue™ setup, my TV, STB (set-top box), or AVR (audio-video receiver) is not
responding to the Keyboard Controller.
Solution: Check the following:
• Is the device IR controlled? Some home theater devices are controlled by line-of-sight, infrared
communication (IR), and others are controlled by high-frequency radio waves (RF). If you are
using the Logitech Revue Companion Box, this device only controls IR-enabled TVs, STBs, and
AVRs, and will not communicate with RF-controlled components.
• Is the IR signal blocked? Use the mini blaster (which comes with your Logitech Revue
Companion Box) to extend the range of the Companion Box IR signal.
• Is the mini blaster close enough to have a direct line of sight with your device? Try moving the
mini blaster closer to the device.
• Is the device still not responding? You may need to teach additional IR commands to your
Logitech Revue Companion Box. Launch the "Logitech Help and More" application from
Logitech Revue to find the video, "Teaching Infrared commands to your Revue."
Problem: How do I enable or disable the tap-to-select feature on the Touchpad?
Solution: If you prefer to tap on the Touchpad instead of clicking, you can enable this gesture by
pressing the Left Ctrl + FN + Ch/Pg Up keys simultaneously. To disable this feature, press the Left
Ctrl + FN + Ch/Pg Down keys simultaneously.
What do you think?
Please take a minute to tell us.
Thank you for purchasing our product.
www.logitech.com/ithink
Logitech® Keyboard Controller
11