Tools Required - Schwinn Evolution Assembly Instructions Manual

step
MATERIALS & TOOLS
#2
Ref. #
1
A
B
39
50
51

Tools Required

A. Position the Front Stabilizer Bar (A) under the frame bracket as shown in the illustration.
B. Make sure the adjustable feet are on the bottom and the transport wheels are facing up and
toward the front of the bike.
CAUTION:
IT IS VERY IMPORTANT TO APPLY GREASE TO THE 13mm HEX BOLT (39) PRIOR TO
MOUNTING THE 13mm LOCKNUT (51) THIS WILL ENSURE THAT YOU CAN REMOVE
THE NUT AT A LATER DATE.
C. Attach Front Stabilizer Bar (A) to Frame (1) using two hex bolts (39), four washers (50), and two
lock nuts (51). Tighten hardware firmly but do not over tighten as deformation of the stabilizer
tube may occur
D. At this time make sure that the adjustable feet with lock nuts are screwed fully into the stabilizer.
E. Position the Rear Stabilizer Bar (B) under the frame bracket as shown in the illustration.
F. Make sure the adjustable feet are on the bottom.
G. Attach Rear Stabilizer Bar (B) to Frame (1) using two hex bolts 39), four washers (50), and two
lock nuts (51). Tighten hardware firmly but do not over tighten as deformation of the stabilizer
tube may occur
H. At this time make sure that the adjustable feet with lock nuts are screwed fully into the stabilizer.
Front
Description
Frame
Front Stabilizer Bar with Wheels and Feet
Rear Stabilizer Bar with Feet
13mm Hex Bolt
Flat Washer
13mm Lock Nut
Stamped Steel Combination Wrench
Adjustable wrench or 13mm Socket (not supplied)
5mm Hex Tool
Rear
NS-75
Evolution / Evolution-SR
Qty
1
1
1
4
8
4
1
1
1
3