Table of Contents
Advertisement
H
IMPORTANT! Use only a Power Wheels
acid rechargeable battery. Use of any other battery will damage
your vehicle. Make sure that you charge the battery for at least
18 hours using the enclosed Power Wheels
charger before operating your vehicle for the first time. Charge the
battery for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow these
instructions may damage your battery and will void your warranty.
1
Lock Fastener
LOCKED
• To unlock the lock fastener, use a slotted screwdriver to rotate the
1
lock fastener
/
turn to the unlocked position
4
• Lift the seat to remove it from the vehicle.
12
BATTERY INSTALLATION
®
6 Volt (4.0 Amp/Hr.) lead-
®
6 Volt (4.0 Amp/Hr.)
Seat
Lock Fastener
Lock Fastener
UNLOCKED
.
Battery Retainer
2
• Loosen and remove the screw in the battery retainer. Remove the
battery retainer.
• Place the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery upright in
the battery compartment. Make sure the battery connector extends
toward the rear of the vehicle.
• Fit one end of the battery retainer into the hole in the vehicle.
• Insert the #8-18 x
7
/
" screw through the end of the battery retainer
8
and into the vehicle. Tighten the screw.
Battery Connector
3
• Fit the battery connector into the motor connector.
Hint: If the battery connector will not plug into the motor connector,
turn it over and try again! Do not force the battery connector into the
motor connector.
• Re-assemble the seat to the vehicle.
IMPORTANT! Always remember to keep the lock fastener locked
at all times to prevent children from accessing the battery.
Motor Connector
K3034pr-0920
Advertisement
Table of Contents
