Sanyo KS1852 Installation Instructions Manual page 11

c) Remove the screws to open the cover plate secur-
ing the electrical component box. (Figs. 25a, 25b,
25c and 25d)
d) Insert the wrapped tubing into the hole in the wall.
e) Hang the indoor unit on the rear panel.
f) Using a Phillips screwdriver, take out the screws on
the earth plate. (Fig. 26a KS0951, 1251 models
only) Remove the earth plate.
g) Remove the lock nut from the conduit connector.
Insert the conduit connector through the opening
from the underside of the electrical component box.
After insertion, Fit the screw at the top of the con-
duit connector into the cut-out. (Fig. 26b). Position
the earth plate over the conduit connector, allowing
the connector and wires to extend through the hole
in the plate. Next, attach the conduit connector to
the earth plate by replacing and tightening the lock
nut (Figs. 26c and 26d). Then re-attach the earth
plate to the electrical component box with the 2
screws.
h) Give some play to the inter-unit wiring from the out-
door unit to the corresponding terminals on the termi-
nal base. (See Wiring System Diagram on page 10.)
WARNING
Be sure to refer to the Wiring System Diagram
label inside the electrical component box and
carry out the correct field wiring. Wrong wiring
can cause the unit to misoperate or result in a fire
hazard.
Check local electrical codes and any specified
wiring instructions or limitations.
i) Fix cover plate and cover plate and back into posi-
tion with their screws.
NOTE
When closing the air intake grille, press on both corners
and the center. (Fig. 27)
Fig. 27
KS0951, KS1251
Electrical
component box
Cover
plate
Fig. 25a
KS1852
Electrical
component box
Cover
plate
Fig. 25c
KS0951, KS1251
Fig. 26a
KS0951, KS1251
Inter-unit
wiring
Lock nut
Top of conduit
connector
Fig. 26c
11
KS0951, KS1251
Terminal
plate
Earth plate
Electrical
component box
Fig. 25b
KS1852
Terminal
plate
Earth plate
Electrical
component box
Fig. 25d
Top of conduit
KS1852
connector
Earth
plate
Screw
Screw
hole
Fig. 26b
Earth
KS1852
plate
Inter-unit
wiring
Lock
nut
Top of conduit
connector
Fig. 26d
Cover
plate
Cover
plate
Earth
plate