Laney LC15-110 Operating Instructions Manual page 13

4 EFFECTS LOOP: SEND/LINE OUT: Connect the input of your external effect to this socket. All of the signal leaves the
amplifier via the `Send' socket to be processed and comes back from the effects via the `Return` socket. This socket can also
be used to control another L
suited to being between the guitar and amplifer input - these are foot pedal types / distortion / wah wah pedals etc. Rack
mount effects will work better in the FX loop on the amplifer rear. Stomp boxes are normally designed for small signals such
as a guitar output whereas rack mount FX are designed for the higher signal level obtained from an FX send. This socket can
also be used as a Line Level Out.
5 BY-PASS/LEVEL SWITCH: This switch allows the effects loop to be by-passed if not in use, it also gives you the option
of running the FX loop at 0dB (750mV) or at -10dB (250mV) to suit your processor.
6 EFFECTS LOOP: RETURN: Connect the output from your external effects to this socket. The effects loop allows you to
connect external effects such as tremolo's, chorus and delays to your amplifier. All of the signal leaves the amplifier via the
`Send' socket and comes back from the effects via the `Return` socket. Use the output level control on your FX to control
how loud the FX return signal sounds. This is an insert type control, therefore you need to set the Dry/ Wet mix in your FX
processor.
7 FOOTSWITCH SOCKET: Provided for the connection of a Laney FS1 footswitch (optional).
8 EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will reduce
the amplifiers performance and in some cases may cause damage to your amplifier. Try the L 15-110 into a Laney extension
cabinet - you will be amazed what this baby cranks out.
9
SERIAL NO: Displays the model and serial number of the unit.
C15 -110 amplifier connected to this socket via its own return socket. Some Effects are better
C