Configure The Rs900W For "Client / Ip Bridge" Operation - RuggedCom RuggedWireless RS900W Family Upgrade Manual

Wireless ethernet with integrated 8-port managed switch, 128-bit encryption

Hide thumbs Also See for RuggedWireless RS900W Family:

h- Set SSID: Ensure that WLAN Interface -> Network Parameters ->

Network Name [SSID] -> RUGGEDTEST is configured.

i- Set Authentication Mode: Ensure that WLAN Interface -> Security

Parameters -> Authentication Mode -> wpa2-psk is selected.

j- Set Encryption Algorithm: Ensure that WLAN Interface -> Security

Parameters -> Encryption Algorithm -> aes is selected.

k- Set Passphrase [WPA,WPA2]: Ensure that WLAN Interface -> Security

Parameters -> Passphrase [WPA,WPA2] -> testing1234 is configured.

l- Soft reset the wireless interface: Ensure that WLAN Interface ->

Miscellaneous Parameters -> WLAN Reset -> Quick reset is selected.

m- After a 'Quick reset' has been executed, the RS900W unit will be

configured for Client/Bridge operation with WPA2 (802.11i) security

enabled. After this step, the Client/Bridge unit will associate with the

similarly configured AP and a 'ping' test should work at this point

2.3 Configure the RS900W for "Client / IP Bridge" operation

The only difference between the configuration of "Client / IP Bridge" and "Client /

Bridge" is the selection of "Operational Mode" in Section 2.2 Step (e). Instead of

setting "Client Bridge" option you will set "Client IP Bridge" option in the

"Operational Mode".

Rev100

Table of Contents