Laney LV100 Instructions Manual page 11

nice crisp blue'sy lead tone. Setting the gain control to midway with a medium volume level will give
you a punchy hard rock lead tone and setting the gain to maximum and backing the volume off, gives
you a full on metal lead tone. Obviously the type of guitar you use will have an effect on the overall
sound you hear.
Controls the overall level on the drive channel. Use in conjunction with .
10
Controls the amount of bass or bottom end present on the drive channel.
11
Controls the amount of mid present on the drive channel.
12
Controls the amount of treble present on the drive channel.
13
The 'VTS Tone Shaping' Radically alters the EQ of the amplifier by cutting some of the lower mid tones
14
and carefully boosting certain bass and upper mid frequencies. It is a global setting and may be used on
any of the channels giving you lots of different sound possibilities.
Sets the amount of reverb applied to the clean channel
15
Sets the amount of reverb applied to the drive channel.
16
The power led will always be lit when the amplifier is switched on.
17
Main power switch for the unit.
18
Always switch off
and disconnect power cord
when not in use
10
11