Manual Settings; Lcd Contrast Setting; Time Zone Setting; Daylight Saving Time On/Off Setting (Dst On/Off) - La Crosse Technology WEATHER STATION Instruction Manual

Hide thumbs Also See for WEATHER STATION:
Table of Contents

Advertisement

* When the signal is successfully received by the Weather Station, the
outdoor transmission icon
will be switched on. If not successful, the
icon will not be shown on LCD. The user can then easily see whether the
last reception was successful (icon on) or not (icon off). A short blinking of
the icon indicates that signal reception is currently taking place.

MANUAL SETTINGS:

The following manual settings can be changed when pressing the SET
key:
x

LCD contrast setting

x

Time zone setting

x
DST ON/OFF setting
x
Time reception ON/OFF setting
x
12/24-hour format setting
x
Manual time setting
x
Calendar setting
x
°F/°C temperature setting
x
Air pressure setting (hPa / inHg)
x
Relative air pressure setting
x
Weather forecasting icon sensitivity setting
The time zone default of the Weather Station is "-5h". U.S. time zones are
negative numbers: –5h(EST), -6h(CST), -7h(MST) and –8h(PST).To set
a different time zone:
1.
The current time zone value starts flashing.
2.
Use the OUT/+ key to set the time zone. The range runs from 0 to -
12 and then runs from +12 back to 0 in consecutive 1-hour
intervals.
3.
Confirm with the SET key and enter the Daylight saving time
ON/OFF.

DAYLIGHT SAVING TIME ON/OFF SETTING (DST ON/OFF)

Flashing
1.
"ON" will flash on the LCD and "DSt" will display.
2.
Use the OUT/+ key to turn the daylight saving time function ON or
OFF.
3.
Confirm with the SET key and enter the Time reception ON/OFF
setting.
12/24-HOUR FORMAT SETTING:
The hour display can be selected to show hours in 12-hour or 24-hour
settings. (Default 12-Hour)
1.
Use the OUT/+ key to toggle between "12H" or "24H".
2.
Confirm with the SET key and enter the Manual time setting.
MANUAL TIME SETTING:
If Weather Station cannot detect the WWVB-signal due to disturbances,
transmission distance, etc., the time can be set manually. The clock will
then work as a normal Quartz clock.
Hour flashing
Minutes flashing
19
21
Flashing
23
Note: SET mode is entered by pressing and holding the SET key for 3
seconds. If you do not press any keys for 15 seconds while in SET
mode, the Weather Station switches out of SET mode.
LCD CONTRAST SETTING:
Last digit flashing
The LCD contrast can be set within 8 levels, from LCD 0 to LCD7 (Default
setting is LCD 4):
1.
Press and hold the SET key until the digit starts flashing.
2.
Use the OUT/+ key to view all levels of contrast.
3.
Select the desired LCD contrast. Confirm with the SET key and
enter in the Time Zone setting.
TIME ZONE SETTING:
TIME RECEPTION ON/OFF SETTING:
Flashing
In areas where reception of the WWVB time is not possible, the WWVB
time reception function can be turn OFF. The clock will then work as a
normal Quartz clock. (Default setting is ON).
4.
"ON" will start flashing on the LCD and "RCC" will display.
5.
Use the OUT/+ key to turn OFF the time reception function.
6.
Confirm with the SET key and enter the 12/24-hour format
setting.
Note:
If the Time Reception function is turned OFF, the clock will not
attempt reception of the WWVB time. The time reception icon and
the "WWVB" icon will not be displayed on the LCD. Time Reception
must be set to "ON" for the WVVB atomic time to function.
1.
The hour digit will start flashing.
2.
Use the OUT/+ key to set the hour.
3.
Press again the SET key to set the minutes. The minute digits start
flashing.
4.
Use the OUT/+ key to set the minutes.
5.
Confirm with the SET key and enter the Calendar setting.
Note:
If the WWVB reception function is set to "ON", the unit will still try to
receive the WWVB time signal between midnight and 6:00 am every day,
even if the time was set manually. When it does receive the signal, it will
change the manually set time into the received time. During reception
attempts, the WWVB tower icon will flash. If reception has been
unsuccessful, then the WWVB tower icon will not appear but reception
will still be attempted the following hour.
CALENDAR SETTING:
Flashing
20
22
Year
24

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents