Replacing The Doors - Amana 12842122 Use & Care Manual

Installation
3. Close doors.
4. Remove top hinge covers by
removing Phillips screws.
5. Unscrew 5 " hex head screws from
⁄
16
top hinges.
For water dispensing
models only:
• Do not remove screw
connecting green ground
wire.
6. For ice and water dispensing models only:
Detach main wire connector harness and red wire
harness.
• To detach main wire
harness, use a flat blade
tool or fingernail to press
junction point between two
connectors to release.
• To detach red wire harness,
press tab on underside of
connector to release.
7. Remove top hinges along with
doors.
8. Remove bottom hinges
with a " hex head driver.
3
⁄
8

Replacing the Doors

• To replace the doors, follow the steps in Door and
Hinge Removal in reverse order.
Important: If water line tube end is damaged, cut off
5 " before reconnecting.
⁄
8
Leveling
To protect personal property and refrigerator
from damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs,
or other protective material.
• Do not use power tools when performing leveling
procedure.
To enhance the appearance and maintain performance,
the refrigerator should be level.
Notes:
• Complete any required door reversal, panel
installation and/or a water supply connection
before leveling.
• Some models only have adjustment screws (A).
Materials Needed:
• 3 " hex head driver
⁄
8
• Carpenter's level
1. Remove toe grille.
• Grasp firmly and pull bottom
outward to unclip.
2. Using hex head driver, turn front adjustment
screws (A) clockwise to raise and counterclockwise
to lower the front of the refrigerator.
A B B
A
4