Sd Cards - JVC VN-H37U series Operation Manual

SD Cards

This unit can record the images you shoot in an SD card (sold separately) inserted in the card slot.
Memo:
If the SD card's switch is set to "Lock", recording and playback cannot be performed. Make sure there is no
critical data on the SD card before disengaging the lock.
If you insert the SD card in the incorrect direction, the camera or the card may be damaged. Always check
that the card has been inserted in the correct direction as shown in the illustration of the SD card slot.
When using VN-H237U/H257U/ H237VPU/H257VPU
When using VN-H37U/H57U/H137U
Follow the steps below to insert an SD card.
1. Loosen the setscrew (1) by rotating it about 3 times, and then open the SD cover.
Note：
Rotating the setscrew 10 times or more may cause it to fall out.
①Lift the setscrew side of the SD cover slightly from the camera body.
※You can pull the setscrew up by its edge to keep it suspended.
②Slide the SD cover to the direction of the setscrew side.
③Lift and open the side with a slit of the SD cover from the camera body.
2. Insert the SD card into the slot until it clicks.
3. Close the SD cover, and retighten the setscrew.
SD card slot
SD card LED
SD card cover
③
②
①
3
SD card slot
SD card LED
SD mark
SD card LED
One (M1.4) setscrew