Belt Cover And Motor Cover - JUKI TL-2010Q Service Manual

Outer Components
1. Arm cover asm.
Disassembly
™ Remove two 1 setscrews.
™ Disconnect and remove 2 con-
nector.

2. Belt cover and motor cover

1 Belt cover setscrew
Disassembly
™ Remove four 1 setscrews and
remove belt cover.
™ Remove three 2 setscrews and
remove motor cover.
3. Face plate asm.
Preparation
™Remove arm cover.
2 Face plate asm. setscrew
SL5040631SE
Disassembly
™ Disconnect 1 connector and 6
remove.
™ Remove 2 setscrews and re-
move 3 face plate asm.
(together with face cover).
1 Arm cover setscrew
SM5042005SN
3 Arm cover
™ Insert 2 connector.
™ Align 6 convex with 5 slit and
tighten the setscrew.
SM5041255SN
™ Attach belt cover and tighten 1
setscrews.
™ Attach motor cover and tighten
2 setscrews.
1 Lamp connector
5 Face cover
™ Attach 3 face plate asm., tighten
it with face plate asm. 2 set-
screws, and attach 6 hand lifter
lever spring.
™ Insert 1 connector.
6 Convex of presser
spring regulator knob
5 Slit of presser regulating screw
4 MAIN circuit
board case cover
Assembly
2 Motor cover setscrew
SM5041255SN
Assembly
Assembly
4
– –
2 Bobbin
winder
connector
Point
™ There should be no torsion or
distorsion in presser spring regu-
lator.
™ Align precisely slit portion with
convex portion.
™ Do not press each lead wire.
Point
™ There should be no difference
in level between belt cover and
front face of frame.
™ Make motor cover come closely
contact with belt cover.
4 Indicating needle of
presser spring regulator
3 Face plate asm.
6 Hand lifter lever spring
Point
™ There should be no difference in
level around the cover when face
cover is closed.
™ 5 should not come in contact
with 4 indicating needle.