Table of Contents
Advertisement
14 Cleaning/Maintenance
Please unplug the power plug from the socket before cleaning and maintenance.
After finishing washing, please turn off the water tap and remove the water inlet pipe.
Unplug the power plug and put back the drain pipe.
If the washer-dryer is not to be used for a long time, please keep the door slightly open and dry the
window pad to avoid unpleasant smell.
Do not use organic solvent or corrosive liquid to wipe the washer-dryer's exterior and rubber parts.
Frequently clean both the water inlet pipe joint and water inlet valve filter screen to prevent them from
being clogged by dirt.
To clean the drain filter (once every 30 days)
(1)
After draining the water in the washer-dryer, press the filter cover with a hand to open it as shown in
Fig. 1.
(2)
Press the push switch to the end to prevent the hand from being wounded when turning the filter knob,
then anticlockwise screw out the drain filter with a hand.
Note: A little water may flow out when screwing out the filter knob (if Err2 alarm appears, relatively
much water may flow out when screwing out the filter knob). Therefore, prepare a container (e.g. basin)
before screwing out the filter knob and make the water flow in the container but not onto the ground or
floor.
(3)
Remove the thrums and impurities on the filter and rinse the filter with clean water.
(4)
Insert the filter along the groove and tighten it by turning clockwise; otherwise water leakage may occur.
Be careful not to distort the filter.
Note: The drain filter must be tightened to avoid water leakage.
(5) Press the push switch again with a hand to make it bounce out, then close the filter cover.
Push
switc
Drain
filter knob
Drain
filter
cover
Fig. 1
Fig. 2
To clean the distributor box
(1) Fully pull out the distributor box.
(2) Slightly lift up and pull out the distributor box.
(3) Rinse the distributor box and siphon cap with clean water.
(4) Buckle the siphon cap, then insert, push in and close the
distributor box.
Note: Please buckle the siphon cap in the correct position of distributor box; otherwise the detergent
and softener in the distributor box cannot be siphoned into the washer-dryer's drum.
19
Loosen
Groove
Drain
filter
Fig. 3
3 Components
Main control panel
Distributor
box
Electroplated
ring
Door
Drain filter
cover
Front adjusttable foot(2)
Drawer
Drying filter box
Tabletop pannel
Door-opening
button
Drain pipe
hook (1 on
each side)
Handle (2
on each
side)
Drain pipe joint
4
Advertisement
Table of Contents
